Описание оборудования | |
---|---|
Single head system | |
General specifications | |
Sensing range | 30 ... 400 mm |
Adjustment range | 40 ... 400 mm |
Dead band | 0 ... 30 mm |
Standard target plate | 20 mm x 20 mm |
Transducer frequency | approx. 310 kHz |
Response delay | minimum : 10 ms factory setting: 37 ms |
Sensor cycle time | ? 10 ms (factory setting) ; programmable to 60 s |
Memory | |
Non-volatile memory | EEPROM |
Write cycles | 300000 |
Indicators/operating means | |
LED green | solid: power on flashing: standby mode or IO-Link communication |
LED yellow | solid: object in evaluation range flashing: programming of the limits, object detected |
LED red | solid: fault flashing: programming limits, object not detected |
Electrical specifications | |
Operating voltage | 18 ... 30 V DC , ripple10%SS |
No-load supply current | ? 50 mA |
Power consumption | ? 500 mW |
Time delay before availability | ? 300 ms |
Interface | |
Interface type | IO-Link (after individual activation via programming button) |
Input/Output | |
Input/output type | 1 synchronization connection, bidirectional |
Synchronization frequency | |
Output | |
Output type | 1 analog output 0 (4) ... 20 mA or 1 analog output 0 ... 10 V |
Resolution | current output: evaluation raИли отправьте нам запрос на voltage output: evaluation raИли отправьте нам запрос на |
Deviation of the characteristic curve | ? ± 1 % of full-scale value |
Repeat accuracy | ? ± 0.1 % of full-scale value |
Load impedance | current output: ? 500 Ohm voltage output: ? 1000 Ohm |
Temperature influence | ? ± 0.75 % of the end value (with temperature compensation) from 10 minutes after switching on the sensor ; 0,17 %/K (without temperature compensation) |
Compliance with standards and directives | |
Standard conformity | |
Approvals and certificates | |
UL approval | cULus Listed, Class 2 Power Source |
CCC approval | CCC approval / marking not required for products rated ?36 V |
Ambient conditions | |
Ambient temperature | current output -25 ... 60 °C (-13 ... 140 °F) voltage output -25 ... 70 °C (-13 ... 158 °F) |
Storage temperature | -40 ... 85 °C (-40 ... 185 °F) |
Mechanical specifications | |
Connection type | Cable connector M12 x 1 , 4-pin , L = 200 mm |
Degree of protection | IP67 |
Material | |
Installation position | any position |
Mass | 20.5 g |
Tightening torque, fastening screws | max. 0.2 Nm |
Factory settings | |
Output | near limit: 40 mm far limit: 400 mm Output mode: rising ramp output type: 4 ... 20 mA |
Beam width |